亚洲一区在线曰日韩下载,99亚洲国产精品精华液,亚洲欧洲国产综合aⅴ无码,欧美亚洲日韩国产系列

① Type B describes the typical drawing quality special killed product previously included in Specification A 622/A 622M.
Specify Type B to avoid carbon levels below 0.02 %.
② The sum of copper, nickel, chromium, and molybdenum shall not exceed 0.50 % on heat analysis. When one or more of these elements is specified, the sum does not apply; in which case, only the individual limits on the remaining elements will apply.
③ Chromium is permitted at the producer option, to 0.25 % maximum when the carbon is less than or equal to 0.05 %. In such case, the limit on the sum of the four elements in Footnote ② does not apply.
④ For carbon levels less than or equal to 0.02 %, columbium and/or titanium may be used as chemical stabilizing elements at the producer option. When such is the case, the limits above do not apply to those elements. Rather, the limit on columbium shall be 0.10% maximum and the limit on titanium shall be 0.15% maximum.

注1：Yield strength and elongation are measured in the longitudinal direction in accordance with Specification A370.
注2：The yield strength tends to increase and the elongation tends to decrease as the sheet thickness decreases. These properties represent those typical of material in the thickness range of 2.5 to 3.5 mm.